•   FPGA based totally reconfigurable 48 powerful TTL pindrivers provide H/L/pull_up/pull_down and read capability for each pin of the socket. Advanced pindrivers incorporate high-quality high-speed circuitry to deliver signals without overshoot or ground bounce for all supported devices. Pin drivers operate down to 1.8V so you'll be ready to program the full range of today's advanced low-voltage devices.
• The programmer performs device insertion tests and contact checks before device programming. These capabilities, supported by overcurrent protection and signature-byte check help prevent chip damage due to operator error.
• Built-in protection circuits eliminates damage to programmer and/or device due to environment or operator failure. All the inputs of the 48Pro programmer, including the ZIF socket, connection to PC and power supply input, are protected against ESD up to 15kV.
• Performs programming verification at the marginal level of supply voltage, improving programming yield and guarantees long data retention.
• Various socket converters are available to handle device in PLCC, SOIC, PSOP, SSOP, TSOP, TSSOP, TQFP, QFN, SDIP, BGA and other packages.

•  USB 2.0 port
• FPGA based IEEE 1284 slave printer port, up to 1MB/s transfer rate
• On-board intelligence: powerful microprocessor and FPGA based state machine
• Three D/A converters for VCCP, VPP1, and VPP2, controllable rise and fall time
• VCCP range 0..8V/1A
•  VPP1, VPP2 range 0..26V/1A
• Autocalibration and Self test capability
• Protection against surge and ESD on power supply input, parallel port connection

 ZIF socket pindriver

•  48-pin DIL ZIF socket accepts both 300/600 mil devices up to 48-pin
• Pindrivers: 48 universal
• VCCP/VPP1/VPP2 can be connected to each pin
•  Perfect ground for each pin
• FPGA based TTL driver provides H, L, CLK, pull-up, pull-down on all pindriver pins
• Analog pindriver output level selectable from 1.8 V up to 26V
• Current limitation, overcurrent shutdown, power failure shutdown
• ESD protection on each pin of socket (IEC1000-4-2: 15kV air, 8kV contact)
•  Continuity test: each pin is tested before every programming operation

 ISP connector

•  10-pin male type with missinsertion lock
• 5 TTL pindrivers, provides H, L, CLK, pull-up, pull-down; level H selectable from 1.8V up to 5V to handle all (low-voltage including) devices.
• 1x VCCP voltage (range 2V..7V/100mA), can be applied to pins 1, 3
• Programmed chip voltage (VCCP) with both source/sink capability and voltage sense
• 1x VPP voltage (range 2V..25V/50mA), can be applied to pins 2,3,4,6,8,10
• Target system supply voltage (range 2V..6V/250mA)